10. Installation
16
_
ART COOL Mirror
Indoor Units
Indoor unit
10.2 Selection of the best location
①
There should not be any heat or steam near the unit.
②
Select a place where there are no obstacles around of
the unit.
③
Make sure that condensation drainage can be conve-
niently routed away.
④
Do not install near a doorway.
⑤
Use a metal detector to locate studs to prevent unneces-
sary damage to the wall.
10.3 Fixing installation plate
The wall you select should be strong and solid enough to
prevent vibration
①
Mount the installation plate on the wall with
type "A" screws. If mounting the unit on a concrete wall,
use anchor bolts.
• Mount the installation plate horizontally by aligning the
centerline using Horizontal meter .
②
Measure the wall and mark the centerline. It is also
important to use caution concerning the location of the
installation plate. Routing of the wiring to power outlets is
through the walls typically. Drilling the hole through the
wall for piping connections must be done safely.
10.4 Before piping work
Good case
• Press on the upper side of clamp and unfold the tubing to
downward slowly.
Unit : mm(inch)
More than
200(7-7/8)
More than
100(3-15/16)
More than
100(3-15/16)
Recommended height
2000(78-3/4)
Installation Plate
Chassis
Hook
Type "A" Screws
Ø70
(Ø2 3/4)
Ø70
(Ø2 3/4)
133(5 1/4)
95(3 3/4)
Right rear piping
Left rear piping
Installation Plate
Place a level on raised tab
Unit Outline
217(8 17/32)
175(6 7/8)
Unit : mm(inch)
• Installation Information. For right piping. Follow the
instruction given below.
CAUTION
Note : Remove obstructions to prevent blockage of air-
flow path
