14
Inserting the battery
When the message [Magic Remote battery is low. Please change the battery.] is displayed, replace
the battery.
To replace batteries, open the battery cover, replace batteries (1.5 V AA) matching the
and
ends to the label inside the compartment, and close the battery cover.
•
Do not mix new batteries with old batteries. This may cause the batteries to overheat and leak.
•
Failure to match the correct polarities of the battery may cause the battery to burst or leak, resulting in fire, personal injury, or ambient
pollution.
•
This apparatus uses batteries. In your community there might be regulations that require you to dispose of these batteries properly due
to environmental considerations. Please contact your local authorities for disposal or recycling information.
•
Batteries inside or inside the product shall not be exposed to excessive heat such as sunshine, fire or the like.
Registering Magic Remote Control
How to register the Magic Remote Control
To use the Magic Remote, first pair it with your TV.
1 Put batteries into the Magic Remote and turn the TV on.
2 Point the Magic Remote at your TV and press the
Wheel (OK)
on the remote control.
* If the TV fails to register the Magic Remote, try again after turning the TV off and back on.
How to deregister the Magic Remote Control
Press the
(Back)
and
(Home)
buttons at the same time, for five seconds, to unpair the Magic Remote with your TV.
* Press and hold the
(Home)
and
(Q. Settings)
buttons for more than 5 seconds to disconnect and re-register the Magic Remote at the
same time.
•
It is recommended that an Access Point (AP) be located more than 0.2 m away from the TV. If the AP is installed closer than 0.2 m, the
Magic remote control may not perform as expected due to frequency interference.
