51
ENG
ENGLISH
CUSTOMIZING SETTINGS
Picture ID Settings
Picture ID
is used to change the settings of a
specific display using a single IR receiver for
multi-vision. Communication is possible between
a monitor with an IR receiver and other monitors
using RS232C cables. Each monitor is identified
by a
Set ID
. If you assign the
Picture ID
using
the remote control, only displays with the same
Picture ID
and
Set ID
can be controlled remotely.
2
Press the
ON
(Red) button on the remote con-
trol to assign the
PICTURE ID
.
1
Assign the
Set ID
to the installed monitors as
shown below:
3
If you press the left/right buttons or the red ON
button for
PICTURE ID
repeatedly, the
Picture
ID
toggles between
OFF
and
1
to
4
. Assign the
Set ID
as you like.
y
A set with a different
Set ID
than the
Picture
ID
cannot be controlled by IR signals.
y
Please refer to the
Installation Manual
for
more information on the assigning
Total Set
ID
.
NOTE
Picture ID
Close
◄ Off ►
2X2 Multi-Vision (Total Set ID: 4)
Set IDs are assigned as shown in the picture.
AUDIO
(RGB/DVI)
REMOTE
CONTROL IN
RS-232C OUT
RS-232C IN
RS-232C OUT
RS-232C IN
RS-232C OUT
RS-232C IN
IR Receiver
RS232C cable
Picture ID
Close
Off
y
If
Picture ID
is set to 2, the upper right
monitor, that has a
Set ID
of 2, can be
controlled by IR signals.
y
If you press the green
OFF
button for
PICTURE ID
, the
Picture ID
s for all monitors
are turned off. If you then press any button
on the remote control, all monitors can be
controlled by IR signals regardless of
Set ID
.
y
The
Picture ID
function may not work while
MY MEDIA
is operating.
