LG 38WR50MS, Owner'S Manual

Page: 47 / 73

46
ENG
ENGLISH
CUSTOMIZING SETTINGS
Picture ID
1
Press the red ON button on the remote control
to assign the Picture ID.
2
If you press the left/right buttons or press the
ON button repeatedly, the Picture ID cycles
through OFF and 1 to 4. Assign the ID you
want.
y y
If you assign the Set ID to each set with
multi-vision, and then assign the Picture ID
using the red button on the remote control,
the key command is displayed for the set
with the same Set ID and Picture ID. A set
with different Set IDs and Picture IDs cannot
be controlled by IR signals.
y y
For more information on how to assign the
Set ID, see "Set ID" on page 43.
y y
The maximum value of the Picture ID can be
set in the Total Set ID menu.
y y
Please refer to the Installation Manual for
more information on Total Set ID assignment.
P
A
G
E
INPUT ENERGY
SAVING
MARK
ARC
ON OFF
. , ! ABC DEF
GHI JKL MNO
PQRS TUV
1/a/A
- * #
WXYZ
CLEAR
OK
S.MENU
MONITOR
PSM
AUTO
MUTE
BRIGHT
NESS
MENU
ID
BACK
TILE
ON
OFF
EXIT
POWER
P
A
G
E
INPUT ENERGY
SAVING
MARK
ARC
ON OFF
. , ! ABC DEF
GHI JKL MNO
PQRS TUV
1/a/A
- * #
WXYZ
CLEAR
OK
S.MENU
MONITOR
PSM
AUTO
MUTE
BRIGHT
NESS
MENU
ID
BACK
TILE
ON
OFF
EXIT
POWER
y y
For example, if the Picture ID is assigned
to 2, the upper right display (Set ID: 2) can
be controlled by IR signals.
y y
For each set, you can change the
settings for the PICTURE, AUDIO, TIME,
NETWORK and MY MEDIA menus or the
hot keys on the remote control.
y y
If you press the green OFF button for
Picture IDs, the Picture IDs for all sets are
turned off. If you then press any button
on the remote control, all sets will start
working again.
y y
Picture ID will be disabled while using the
MY MEDIA menu.
NOTE
Picture ID
Close
Off
When using the 4 Set (Total Set ID: 4)
Set IDs are assigned as shown in the picture.
Picture ID is used to change the settings of
a specific set using a single IR receiver. The
set receiving the IR signal communicates with
another set via an RS232C connection. Each set
is identified by a Set ID. If you assign the Picture
ID using the remote control, only displays with
the same Picture ID and Set ID can be controlled
remotely.
IR Receiver
RS232C cable
Picture ID
Close
Off