12
ENGLISH
CAUTION
•
Disconnect the power first, and then move or install the TV.
Otherwise electric shock may occur.
•
Remove the stand before installing the TV on a wall mount by
performing the stand attachment in reverse.
•
If you install the TV on a ceiling or slanted wall, it may fall and
result in severe injury. Use an authorised LG wall mount and
contact the local dealer or qualified personnel.
•
Do not over tighten the screws as this may cause damage to the TV
and void your warranty.
•
Use the screws and wall mounts that meet the VESA standard. Any
damages or injuries by misuse or using an improper accessory are
not covered by the manufacturer’s warranty.
NOTE
•
Use the screws that are listed on the VESA standard screw
specifications.
•
The wall mount kit includes an installation manual and necessary
parts.
•
The wall mount bracket is not provided. You can obtain additional
accessories from your local dealer.
•
The length of screws may differ depending on the wall mount.
Make sure to use the proper length.
•
For more information, refer to the manual supplied with the wall
mount.
•
When installing the wall mounting bracket, use the adhesive
label provided. The adhesive label will protect the opening from
accumulating dust and dirt. (Only when the label is provided)
Provided item
Adhesive label
•
When attaching a wall mounting bracket to the TV, insert the wall
mount spacers into the TV wall mount holes to adjust the vertical
angle of the TV. (Only when the item of the following form is
provided)
Provided Item
Wall Mount Spacer
Attaching the shelf stand
(Only LF515*)
350 mm
150 mm
Shelf stand
STB
(Set top box)
Shelf stand conditions of use
STB Dimensions (W x D)
350 mm x 150 mm
STB Weight
2.5 kg
Maximum supported weight
3.5 kg
How to attach to masonry walls
(Only LF515*)
Use the anchors for wall material of concrete, light concrete, strong
natural stone, soft natural stone masonry brick and hallow block that
do not crack.
Please follow the below direction
(Only LF515*)
-
Check the material of the wall and the thickness of the finishing.
-
When installing the product on wall material not designated,
install the product so that each fixated location can withstand
the pull out load of 70 kgf (686 N) and shear load of 100 kgf (980
N) or above.
-
Use the Ø8 mm drill bit for concrete and hammer (Impact) drill.
