ENGLISH
13
Satellite dish connection
(Only satellite models)
Connect the TV to a satellite dish to a satellite socket with a satellite RF
cable (75 Ω).
HDMI ULTRA HD deep colour
settings
(Only UF67**)
•
SETTINGS PICTURE HDMI ULTRA HD Deep Colour
HDMI (1/2) ULTRA HD Deep Colour
-
On :
Support 4 K @ 50/60 Hz (4:4:4, 4:2:2, 4:2:0)
-
Off :
Support 4 K @ 50/60 Hz (4:2:0)
•
All HDMI ports support the HDCP 2.2.
•
4 K Source is only supported in HDMI input.
•
4 K signal and content are not available in the RF/USB input.
•
All HDMI input ports support 4 K @ 50/60 Hz (For details on the
supported specifications, refer to the table below.) for high-
definition video. Picture or sound may not be supported depending
on the specifications of the external device connected. In that case,
change the settings for
HDMI ULTRA HD Deep Colour
.
4 K @ 50/60 Hz Support Format
Resolution
Frame rate
(Hz)
Colour Depth /
Chroma Sampling
8 bit
10 bit 12 bit
3840 x 2160p
4096 x 2160p
50.00
59.94
60.00
YCbCr 4:2:0
YCbCr 4:2:0
1
YCbCr 4:2:2
1
YCbCr 4:4:4
1
-
-
RGB 4:4:4
1
-
-
1 : Only supported when
HDMI ULTRA HD Deep Colour
turned “
On
”.
CI module connection
(Depending on model)
View the encrypted (pay) services in digital TV mode.
•
Check if the CI module is inserted into the PCMCIA card slot in the
right direction. If the module is not inserted properly, this can
cause damage to the TV and the PCMCIA card slot.
•
If the TV does not display any video and audio when CI+ CAM is
connected, please contact to the Terrestrial/Cable/Satellite Service
Operator.
Euro Scart connection
(Depending on model)
Transmits the video and audio signals from an external device to the
TV set. Connect the external device and the TV set with the euro scart
cable.
Output
Type
Current
input mode
AV1
(TV Out
1
)
Digital TV
Digital TV
Analogue TV, AV
Analogue TV
Component
HDMI
1 TV Out : Outputs Analogue TV or Digital TV signals.
•
Any Euro scart cable used must be signal shielded.
•
When watching digital TV in 3D imaging mode, only 2D out signals
can be output through the SCART cable. (Only 3D models)
Other connections
Connect your TV to external devices. For the best picture and audio
quality, connect the external device and the TV with the HDMI cable.
Some separate cable is not provided.
Remote control
(Depending on model)
The descriptions in this manual are based on the buttons on the remote
control. Please read this manual carefully and use the TV correctly.
To replace batteries, open the battery cover, replace batteries (1.5
V AAA) matching the and ends to the label inside the
compartment, and close the battery cover. To remove the batteries,
perform the installation actions in reverse.
CAUTION
•
Do not mix old and new batteries, as this may damage the remote
control.
•
The remote control will not be included for all sales market.
Make sure to point the remote control toward the remote control sensor
on the TV.
