21
EN
Connecting the Water Line
(For Plumbed models Only)
Accessories
Water Filter
Water Tube
Water Supply Requirements
A cold water supply with water pressure
between 138 kPa and 827 kPa (1.4-8.4 kgf/cm²)
is requried to operate the water dispenser. If the
refrigerator is installed in an area with low water
pressure (below 138 kPa), you can install a
booster pump to compensate for the low
pressure.
If a reverse osmosis water filtration system is
connected to your cold water supply, the water
pressure to the reverse osmosis system needs
to be a minimum of 138 kPa to 827 kPa
(1.4-8.4 kgf/cm²)
WARNING
•
Unplug the appliance before carrying out any
work on connecting the water line. Failure to
do so may cause electric shock.
•
Only connect the water line to a cold water
supply. Failure to do so may cause the water
filter to malfuction. Water hammer (water
banging in the pipes) in house plumbing can
cause damage to appliance parts and can
lead to water leakage or flooding.
•
Connecting the water line must only be
installed by a qualified plumber and in
accordance with local legislation and
regulations governing water quality.
NOTE
•
This water line installation is not covered by
the appliance warranty.
Connecting to the Appliance
1
Remove the cap from the tube connector on
the back side of the refrigerator.
2
Connect the installation tube to the
connector.
Checking the Water Connection
1
Turn on the water supply and switch on the
appliance. Carefully check all fittings for
possible leaks due to poorly fitted hoses.
2
Press and hold the
Water Filter
button for
three seconds. That resets the Replacement
Filter icon. The new water filter has been
activated.
3
Place a cup under the water dispenser to
verify that water is flowing through the
appliance.
4
Check the connecting tube and joints for
leaks once again.
Summary of Contents for SG51700TSL
