iPECS-MG Hardware Description and Installation Manual
Issue 1.1
DECT INSTALLATION
August, 2010
77
6.1.5 Wall Mount
6.1.5.1 LDP-7000 and LIP-7000 Wall Mounting
The LDP-7000 or LIP 7000 series phones can be mounted on the wall using the appropriate Wall
Mount Kit. The Wall Mount Kit is installed as described below and shown in Figure 6.1.5.1-1.
Using the appropriate Wall Bracket, mark and drill two (2) 7 mm holes for the plastic wall anchors
provided.
Insert the two (2) anchors into the holes and insert and tighten the 2 screws leaving about 6 mm
(¼-inch) exposed. Refer to Figure 6.1.5.1-1.
Connect one end of a short cable terminated in RJ11s or RJ45s to the LDP-7000 or LIP 7000
series Phone, respectively, and the connect the other end in a wall jack.
Mount Wall Mount bracket on the phone.
Slide the Wall Mount bracket over the screws, if loose, tighten the screws slightly and mount the
Wall Mount bracket again.
Insert the Wall Mount handset hook to prevent the handset from slipping when wall mounted. For
the LIP-7000 series, the Handset hook is molded as part of the Wall Mount bracket as shown in
Figure 6.1.5.1-1.
Figure 6.1.5.1-1 LIP-7000 Wall Mount Installation
6.1.5.2 LIP-8000 Wall Mounting
The LIP-8000 series phones incorporate wall mount into the base of the phone housing. Using the
instructions below and Figure 6.1.5.2-1, wall mount the LIP-8000 phone.
Mark and drill two (2) 7mm holes for plastic wall anchors.
Insert the two (2) anchors into the holes and insert and tighten the 2 screws leaving about 2.5 mm
(1/8-inch) exposed. Refer to Figure 6.1.5.2-1.
Slide the LIP-8000 phone over the screws and assure the phone is secure. Note it may be
necessary to remove the phone and tighten or loosen the screws for a secure mounting.
Remove the Handset hook from the phone as shown in the figures below. Reverse the hook and
re-install in the LIP-8000 phone so that the hook catches the groove in the handset receiver.
