iPECS-MG Hardware Description and Installation Manual
Issue 1.1
DECT INSTALLATION
August, 2010
75
6.1.4 DSS/BLF Console Installation & Wiring
6.1.4.1 LDP-7048 DSS Install
The digital LDP-7048 DSS/BLF Console is provided with a phone-mounting bracket, used to fasten
the Console to the phone securely. To attach the fastener,
turn the Console and phone upside down,
place the fastener in position,
insert and tighten screws. Caution, do not over-tighten as this may damage the plastic phone
housing.
Figure 6.1.4.1-1 LDP-7048 and LIP-7048 Console Install
6.1.4.2 LDP-7048 and LIP-7048 DSS Console Wiring
The LDP-7048 DSS Console is wired as a normal Digital Key Telephone to a separate port of a DISU
or DTIB, refer to section 6.1.2.1. The LIP-7048 DSS Console is wired as a normal LIP-7000 series IP
Phone, refer to section 6.1.2.3. The LIP-7048 DSS Console must be powered by a POE compatible
Ethernet switch port or the AC/DC adaptor-K for the LIP Phones.
6.1.4.3 LIP-8000 DSS Installation and Wiring
The LIP-8000 Series DSS/BLF Console is available in three (3) models 12 button w/paper labels
(LIP-8012DSS), 12-button w/LCD (LIP-8012LSS), and 48-button w/paper labels (LIP-8048DSS). Up
to four (4) consoles can be connected to an LIP-8000 series phone using the serial ribbon cable from
the console. A maximum two (2) LCD DSS Consoles can be supported and, when more than two
consoles are connected, one must be the 48-button Console. In all cases, the 48-button Console
must be powered by the AC/DC Adaptor-K.
Referring to install an LIP-8000 series DSS Console,
turn the LIP phone and DSS Console upside down
remove the rubber plug in the LIP phone protecting the DSS serial cable connector.
insert the flat ribbon cable from the DSS Console into the connector in the LIP phone.
