simultaneously.
If you set a different address, each unit will start to “listen” to the channel number you have set,
based on the quantity of control channels of the unit. That means changing the settings of one
channel will affect only the selected fixture.
In the case of the spot head, which is a 11 channel fixture, you should set the starting address of the
first unit to 1, the second unit to
9 (8 + 1), the third to 17 (9 + 8), and so on.
Note:
The odes
wn via the
m
of DMX 512 data and lamp are sho
display:
. .
.
.
Lamp on
Lamp on
DMX OK
DMX OK
NO DMX
NO DMX
Lamp off
Lamp off
1. After switching on, the device will automatically detect whether DMX 512 data is received or not. If the data is
received, the the display will show
"A.001"
with the actually set address. If there is no data received at the
DMX-input, the display will flash
"A001"
with the actually set address.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap in the
input connector.
It’s necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to ensure
proper transmission on the DMX data link.
2. If the lamp is on, the the display will show
"A00.1"
with the actually set address. If the lamp is off, the the
display will show
"A001"
with the actually set address.
Control Board
The Control Board offers several features: you can simply set the starting address, switch on and off the lamp, run
the pre-programmed program or make a reset.
The main menu is accessed by pressing the Mode/esc-button until the display starts flashing. Browse through the
menu by pressing the Up-button or Down-button. Press the Enter-button in order to select the desired menu. You
can change the selection by pressing the Up-button or Down-button. Confirm every selection by pressing the
Enter-button. You can leave every mode by pressing the Mode/esc-button . The functions provided are described in
the following sections.
- 9 - WIT044 V1.6-03NR
