Manual CT26-15 - LFB
13
Assembly of the rear wheel:
Take the wheel and put the chain on the smallest sprocket right side, then engage the wheel between the
brake pads.
r
w
arning
! t
he
Motor
shaFt
has
an
axle
with
2
Flat
sides
. i
t
should
be
positioned
to
allow
it
to
pass
in
the
FraMe
. t
o
do
this
it
is
soMetiMes
necessary
to
rotate
the
axle
.
Flat sie of the axle
Passage frame.
Returning to the back, insert the wheel axle in the housing right and left of the frame. Put washers and wheel
nuts. Tighten the nuts by hand at first so they touch the frame.
r
w
arning
! o
n
each
side
there
is
a
washer
with
Flat
«
pin
». t
he
pin
should
always
be
positioned
in
the
openings
oF
the
FraMe
to
prevent
the
axle
FroM
turning
on
itselF
.
Washer with flat pin.
To prevent the motor rotates the axle and not
the wheel, ensure that the pin is locked in the
frame.
Center the wheel in the frame. Control the centering and positioning in line with the front wheel, and the
positioning of the chain.
Screw without tighten wheel nuts on each side. Recheck the positioning, centering and position of the chain.
Tighten alternately and gradually on each side of the wheel the nuts (tightening torque 40 Nm max). Replace
nuts caches.
Flat pin
Flat sie
of the
axle.
Flat sie
of the
axle.
