2.3 Interface control panel
Figure 2. Interface control panel
1.
Start button
2.
Standby button
3.
Standby decrease button
4.
Standby increase button
5.
Alarm indicator LED
6.
Service indicator LED
7.
Auto
‑
run indicator LED
8.
Standby increase indicator LED
9.
USB port (not for operation)
10.
Standby decrease indicator LED
11.
Standby indicator LED
12.
Run indicator LED
13.
Stop button
14.
Power status LED
1.
Start button
2.
Standby button
3.
Standby decrease button
4.
Standby increase button
5.
Alarm indicator LED
6.
Service indicator LED
7.
Auto
‑
run indicator LED
8.
Standby increase indicator LED
9.
USB port (not for operation)
10.
Standby decrease indicator LED
11.
Standby indicator LED
12.
Run indicator LED
13.
Stop button
14.
Power status LED
2.3.1 Auxiliary connector socket
An auxiliary control connection on the rear panel controls an optional inlet
valve. This inlet valve can be operated in parallel with the normal pump
output signal. Refer to
, (7). The valve is usually closed
and:
▪
will open when the normal signal becomes active (pump at speed)
▪
will close when you select the stop button or if there is a fault
condition.
The reaction time will be in line with the valve selection and the output signal
is 24 V d.c., refer to
for the polarity of the connector
pins when the connector is energized.
The auxiliary connector is regulated to 24 V d.c. to control the accessories. If
the auxiliary load current exceeds the value in
Table: Auxiliary load currents
,
the output will shut down to protect the pump controller. Refer to
for the recommended mating plugs.
11
300902516_002 - 10/2020 - © Leybold
General description
Summary of Contents for ECODRY plus 25
Page 5: ...11 Disposal 55 12 Accessories 56 12 1 Electrical cables 56 Contents...
Page 57: ...57 300902516_002 10 2020 Leybold Accessories...
Page 61: ...This page has been intentionally left blank...
Page 62: ...This page has been intentionally left blank...
