602494EA.DOCX
17200234_002_C1/2016 - © Leybold
45/102
The «Configuration» display shows the current
settings of the operating mode, valve type, pressure
sensor, and nominal value (setpoint) with source
(I = internal, E = external). Press
to get to the «General settings» display.
The «General settings» display shows the LCD
contrast, measurement unit of the pressure, language,
automatic booting and automatic reset function.
Press
4x
to edit the setting of the automatic
booting function.
to return to the «Configuration» display.
The Edit symbol is displayed in the «Autoboot» line.
Press
to set the automatic booting function to
on
or
off
.
to save the new setting and return to the
«Configuration» display.
5.2.5
Automatic Reset Function
This function is only effective in the Pressure control mode.
This setting determines how the CMOVE 1250 will behave in the following cases:
•
The operating mode was changed from Pressure to Flow and then back to Pressure
•
Signal «Externally CLOSE» (DI 3) active
•
Signal «Externally OPEN» (DI 4) active
GEN.
VALVE SENSOR I/O GEN.
Mode : Pressure
Valve : MOVE1250STD
Sensor : CTR1000T
Nom. I : 1.33E+01 mbar
Configuration
4×
General settings
LCD-Contrast : 30
Measure : mbar
Language : english
Autoboot : on
Autoreset : off
General settings
LCD-Contrast : 30
Measure : mbar
Language : english
Autoboot : on
Autoreset : off
