Lexus UX 250h 2020, Owner'S Manual

Page: 231 / 480

229
4-5. Using the driving support systems
4
Dr
ivi
ng
Use the meter control switches to turn
on/off the function (

P.87).
1 Press or to select .
2
Press or to select and
then press “OK”.
WARNING
● Keep the sensors and the surrounding
areas on the rear bumper clean at all
times.
If a sensor or its surrounding area on the
rear bumper is dirty or covered with
snow, the Blind Spot Monitor may not
operate and a warning message
(

P.227) will be displayed. In this situa-
tion, clear off the dirt or snow and drive
the vehicle with the operation conditions
of the BSM function (

P.231) satisfied
for approximately 10 minutes. If the
warning message does not disappear,
have the vehicle inspected by your Lexus
dealer.
● Do not attach stickers to the sensor or
surrounding area on the rear bumper.
● Do not subject a sensor or its sur-
rounding area on the rear bumper to a
strong impact.
If a sensor is moved even slightly off posi-
tion, the system may malfunction and
vehicles may not be detected correctly.
In the following situations, have your
vehicle inspected by your Lexus dealer.
• A sensor or its surrounding area is
subject to a strong impact.
• If the surrounding area of a sensor is
scratched or dented, or part of them
has become disconnected.
● Do not disassemble the sensor.
● Do not modify the sensor or surround-
ing area on the rear bumper.
● Do not paint the rear bumper any
color other than an official Lexus color.
Turning the Blind Spot Monitor
on/off