Lexus RC 300 2019, Owner'S Manual

Page: 289 / 475

287
5
5-5. Using the other interior features
In
ter
ior f
eat
ur
es
devices registered to them can be
overwritten:
1 With one hand, press and hold the
desired HomeLink
®
button.
2 When the HomeLink
®
indicator
starts flashing (orange), continue to
hold the HomeLink
®
button and
perform “Programming
HomeLink
®
”
1
(it takes 20 seconds
for the HomeLink
®
indicator to
start flashing).
■
Before programming
●
Install a new battery in the transmitter.
●
The battery side of the transmitter must
be pointed away from the HomeLink
®
.
Press the appropriate HomeLink
®
button. The HomeLink
®
indicator light
should turn on.
The status of the opening and closing
of a garage door is shown by the indi-
cators.
Opening
Closing
This function is only available if the garage
door opener motor used is a compatible
device. (To check device compatibility,
refer to www.homelink.com.)
The indicators can operate within
approximately 250 m (820 ft.) of the
garage door. However, if there are
obstructions between the garage door
and the vehicle, such as houses and
trees, feedback signals from the
garage door may not be received.
To recall the previous door operation
status, press and release either
HomeLink
®
buttons and
or and simulta-
neously. The last recorded status will
be displayed for 3 seconds.
Press and hold the 2 outside buttons
for 10 seconds until the HomeLink
®
indicator light changes from continu-
ously lit (orange) to rapidly flashing
(green).
If you sell your vehicle, be sure to erase the
programs stored in the HomeLink
®
mem-
Operating HomeLink
®
A
B
Color Status
Orange (flashing)
Currently open-
ing/closing
Green
Opening/closing has
completed
Red (flashing)
Feedback signals
cannot be received
Erasing the entire HomeLink
®
memory (all three codes)
RC350-RC300_OM_General_OM24884E