Lexus RC 300 2019, Owner'S Manual

Page: 236 / 475

234 4-5. Using the driving support systems
■
The Lexus parking assist-sensor can be
operated when
●
Front center sensors:
• The engine switch is in IGNITION ON
mode.
• The shift lever is in a position other than P
or R.
• The vehicle speed is less than about 10
km/h (6 mph).
●
Front corner sensors:
• The engine switch is in IGNITION ON
mode.
• The shift lever is in a position other than P.
• The vehicle speed is less than about 10
km/h (6 mph).
(At any speed when the shift lever is in R)
●
Rear corner and rear center sensors:
• The engine switch is in IGNITION ON
mode.
• The shift lever is in R.
■
Muting the buzzer sound
●
To mute the buzzer sound:
The buzzer can be temporarily muted by
pressing “OK” of the meter control
switches while an obstacle detection dis-
play is shown on the multi-information dis-
play.
●
To cancel the mute:
Mute will be automatically canceled in the
following situations.
• When the shift position is changed
WARNING
■
When to disable the function
In the following situations, disable the
function as it may operate even though
there is no possibility of a collision.
●
The vehicle is equipped with a fender
pole, wireless antenna or fog lights.
●
The front or rear bumper or a sensor
receives a strong impact.
●
A non-genuine Lexus suspension
(lowered suspension, etc.) is installed.
●
Towing eyelets are installed.
●
A backlit license plate is installed.
■
When using Lexus parking assist-sen-
sor
In the following situations, the system
may not function correctly due to a sen-
sor malfunction, etc. Have the vehicle
checked by your Lexus dealer.
●
The Lexus parking assist-sensor oper-
ation display flashes or shows continu-
ously, and a beep sounds when no
objects are detected.
●
If the area around a sensor collides
with something, or is subjected to
strong impact.
●
If the bumper or grille collides with
something.
●
If the display flashes or is displayed
continuously and a buzzer does not
sound, except when the mute function
has been turned on.
●
If a display error occurs, first check the
sensor.
If the error occurs even when there is
no ice, snow or mud on the sensor, it is
likely that the sensor is malfunctioning.
■
Notes when washing the vehicle
Do not apply intensive bursts of water or
steam to the sensor area.
Doing so may result in the sensor mal-
functioning.
●
When using a high pressure washer to
wash the vehicle, do not spray the sen-
sors directly, as doing so may cause a
sensor to malfunction.
●
When using steam to clean the vehicle,
do not direct steam too close to the
sensors as doing so may cause a sen-
sor to malfunction.
RC350-RC300_OM_General_OM24884E