Lexus NX 300h 2016, Owner'S Manual

Page: 320 / 680

320
4-5. Using the driving support systems
NX300h_OM_USA_OM78082U
■
The Blind Spot Monitor function is operational when
●
The BSM main switch is set to on
●
Vehicle speed is greater than approximately 10 mph (16 km/h).
■
The Blind Spot Monitor function will detect a vehicle when
●
A vehicle in an adjacent lane overtakes your vehicle.
●
Another vehicle enters the detection area when it changes lanes.
■
Conditions under which the Blind Spot Monitor function will not detect a vehicle
The Blind Spot Monitor function is not designed to detect the following types of vehicles
and/or objects:
●
Small motorcycles, bicycles, pedestrians, etc.
*
●
Vehicles traveling in the opposite direction
●
Guardrails, walls, signs, parked vehicles and similar stationary objects
*
●
Following vehicles that are in the same lane
*
●
Vehicles driving 2 lanes across from your vehicle
*
*
: Depending on conditions, detection of a vehicle and/or object may occur.
■
Conditions under which the Blind Spot Monitor function may not function correctly
●
The Blind Spot Monitor function may not detect vehicles correctly in the following con-
ditions:
• During bad weather such as heavy rain, fog, snow, etc.
• When ice or mud, etc., is attached to the rear bumper
• When driving on a road surface that is wet due to rain, standing water, etc.
• When there is a significant difference in speed between your vehicle and the vehicle
that enters the detection area
• When a vehicle is in the detection area from a stop and remains in the detection
area as your vehicle accelerates
• When driving up or down consecutive steep inclines, such as hills, a dip in the road,
etc.
• When multiple vehicles approach with only a small gap between each vehicle
• When vehicle lanes are wide, and the vehicle in the next lane is too far away from
your vehicle
• When the vehicle that enters the detection area is traveling at about the same speed
as your vehicle
• When there is a significant difference in height between your vehicle and the vehicle
that enters the detection area
• Directly after the BSM main switch is set to on
●
Instances of the Blind Spot Monitor function unnecessarily detecting a vehicle and/or
object may increase under the following conditions:
• When there is only a short distance between your vehicle and a guardrail, wall, etc.
• When there is only a short distance between your vehicle and a following vehicle
• When vehicle lanes are narrow and a vehicle driving 2 lanes across from your vehi-
cle enters the detection area
• When items such as a bicycle carrier are installed on the rear of the vehicle