Lexmark Optra N model 240, Service Manual

Page: 16 / 105

2-3
4040 Finisher
Operator Error Message Table
If you have a paper jam, be sure to clear all paper from the finisher,
paper deck, and printer. If you are unable to clear an operator error
code for a paper jam; note the location of the paper jam and check
the paper sensor for that station. See
“Switches” on page 4-4 or
“Sensors” on page 4-5 . If the sensors are working properly, see the
“Service Checks” on page 2-10 for other mechanical failures. If no
paper is present you must open a finisher cover to clear the error
code.
Message Action
30 Finisher Door Open (MS1,
MS7) Be sure the finisher top cover, right
access door, and stapler access
door are completely closed. If the
error does not clear, check the door
switches and replace if necessary.
31 Finisher Interlock Open (PI-15) Be sure the finisher is positioned
snugly against the printer and the
latches on either side of the finisher
are snapped in place. If the error
does not clear, check the interlock
sensor. Replace if necessary.
41 Paper Jam (PI-1) There is a paper jam in the input
area, right access door. If the error
code does not reset after you clear
the paper jam, go to the
“Paper Jam,
41, Paper Input Service Check” on
page 2-12
. If there is still a problem
after that, go to the “Symptom Table”
on page 2-7 .
42 Paper Jam (PI-2) There is a paper jam at the right
access door. If the error code does
not clear after you clear the paper
jam, go to the
“Paper Jam, 42,
Reversing Paper Sensor Service
Check” on page 2-13
. If there is still
a problem after that, go to the
“Symptom Table” on page 2-7 .