Lexmark Optra C, Service Manual

Page: 181 / 328

4-52
Transfer Drum and Holder Assembly
See Assembly 29-1.
Note: This procedure removes the transfer drum assembly from the
transfer drum holder assembly.
1. Remove the transfer drum and holder assembly.
2. Remove the 4 screws from the two transfer drum holder covers
and remove the covers.
3. Remove the screw from the drum knob assembly and remove
the knob.
4. Remove the spring and three screws from the separation claw
and remove the claw.
5. Remove the two springs from the attraction roller holder.
6. Remove the connector shield from the back of the holder front
plate.
7. Disconnect the three connectors in the holder front plate.
8. Remove the two screws from the waste toner cartridge lock
bracket located on the transfer drum holder front plate and
remove the bracket.
9. Remove the extension spring from the transfer drum holder rear
plate.
10. Remove the front and rear levers from the transfer drum holder
plates. The rear lever is mounted to a stud in the plate. The front
lever is mounted with a pin. Remove the screw from the pin and
remove the pin.
11. Remove the two screws from the pin located at the bottom right
corner of the transfer drum holder front plate and remove the
pin.
12. Lift the transfer drum assembly out of the transfer drum holder
assembly.