SSeettuupp
Bargraph
LEDs stay lit, too much
signal is being sent to the MX200;
reduce the Aux Master or Aux send on
the mixer.
9. Turn up the Aux Return to the 12
o’clock position (or line input faders to
the 0db positions, if you used that
connection).
10. To increase or decrease the amount of
effect on the signal, adjust the Aux
Send level on the channel that you
want affected.
Mixer - Dual Mono Setup
This setup applies to a mixer with two (or
more) Aux Sends and Returns. It utilizes
the two effect sections in the MX200 as
two separate effects with separate mono
outputs, or a common stereo output.
1. Select routing 1 or 4 using the
Routing
button.
2. Connect Aux 1 send to the MX200
Left
input.
3. Connect Aux 2 send to the MX200
Right
input.
4. Connect the MX200
Left
and
Right
outputs to the mixer’s Aux returns 1 and
2 for mono, or Stereo Aux L/R returns
for stereo.
5. Set
Mix 1
and
Mix 2
knobs fully
clockwise (Wet).
6. Set the MX200’s
Input
knob to the 12
o’clock position.
7. Set the Aux Return levels on the mixer
to 12 o’clock.
8. Turn up Aux Sends 1 and 2 on the
mixer for the selected channels so the
red
Input Bargraph
LEDs only light
occasionally with signal (adjusting the
Input
knob on the MX200 may be
necessary).
9. Control the amount of effect using the
Aux Send levels on the selected mixer
channels.
Serial Connections
Guitar - Effects Loop Setup
1. Select routing 2 using the
Routing
button (you can always experiment
using other routings).
2. Connect guitar to the amp’s Input.
3. Connect the amp Effects Loop Send or
Preamp Out to the MX200’s
Left
input.
4. Connect the MX200’s
Left
output to the
amp’s Effects Loop Return or Power
Amp In.
5. Set
Mix 1
and
Mix 2
knobs to the 12
o’clock position.
6. Adjust the
Input
level so the red
Input
Bargraph
LEDs only light occasionally
with signal.
7. To adjust the effect level, use the
Mix 1
and
Mix 2
knobs.
Preamp
Out
Power Amp
In
Aux
Send 1
Aux
Return 1
Aux
Send 2
Aux
Return 2
8
