the MX200 will have a signal source (such
as an instrument) connected directly to its
inputs and the MX200’s outputs are con-
nected to a mixer or amplifier input chan-
nels. The difference between these two
banks is the way the
Mix 1
and
Mix 2
con-
trols are set in the Factory programs, pro-
viding the proper wet/dry mix for either
application.
Note
: The default Factory bank is the
Serial bank. If you plan to use the MX200
as a Parallel device in a mixer Aux
Send/Return setup, select the Parallel
bank of Factory programs.
To select the Parallel bank of Factory pro-
grams:
1. Press both the
Store
and
Audition
buttons simultaneously until
Ut
appears
in the
Program Display
.
2. Press the
Audition
button repeatedly
until
Fb
appears in the
Program
Display
. This is the Factory Bank
program select menu. The
Program
Display
alternately flashes
Fb
and then
SE
to indicate the Serial bank
of Factory programs is selected.
3. To select the Parallel bank of Factory
programs, turn the
Program Select
knob until
PA
appears in the
Program
Display
.
4. Press the
Store
button to save these
changes.
Bypass Mode Select
From the factory, MX200 is configured so
that engaging the Bypass button on P1 or
P2 causes that processor to go into
Bypass mode, allowing dry, unprocessed
signal to pass through unaffected. There
are cases when you may want to have this
button mute the output altogether, allowing
neither wet nor dry signal to pass. Note
that this configuration should only be used
for Routing options 1, 3 and 4; placing
either Processor in Bypass (mute) when
Routing 2 (Cascade) is selected will cause
the MX200 to have no output, as the entire
signal is muted by the Processor placed in
Bypass.
To change this setting:
1. Press both the
Store
and
Audition
buttons simultaneously.
2. Press the
Audition
button repeatedly
until
bP
appears in the
Program
Display
. The
Program Display
flashes
between
bP
and
dr
(indicating dry
signal).
3. Turn the
Program Select
knob until the
display reads
no
(or no signal).
4. Press the
Store
button to save this
change.
Factory Reset
Use this utility if you want to erase all User
program data and restore the MX200 to its
factory state.
To perform a
Factory Reset
:
1. Press both the
Store
and
Audition
buttons simultaneously.
2. Press the
Audition
button repeatedly
until
Fr
appears in the
Program
Display
3. To restore the MX200 to its factory state,
press the
Store
button. The
Store
button begins to flash.
Warning
: Pressing and holding the
Store
button again at this time resets all Utility
menus to their factory defaults and perma-
nently erases all User programs! This will
not affect the Factory programs or any pro-
grams saved to your computer using the
MX-Edit Librarian software.
4. Press and hold the
Store
button to
complete the reset procedure. The
display flashes
rs
to indicate the
Factory Reset
was successful.
M
MXX220000 U
Uttiilliittiieess
25
