Lexicon I-O|42, Owner'S Manual

Page: 23 / 32

17
Set Up Cubase
®
LE for IO 42 (Mac
®
)
1. Make sure the included USB cable is connected to your computer and to
the IO 42, the Mixer is open, and the IO 42 is turned on.
2. Open Cubase LE (located in the Applications folder), and go to
Devices>Device Setup as shown below.
3. Click VST Audio System and select Lexicon IO 42 as the ASIO Driver
if it is not already selected.
4. Cubase
®
LE will now ask you if you would like to switch the driver.
Select Switch then OK.
5. Ensure the driver is loaded by clicking Reset. Then click OK.
Mac
®
OS 10.4.x users only: After selecting Lexicon X4 as the ASIO Driver,
you may need to verify that your device inputs are active. To do this, follow
these steps:
1. Select Device>VST Connections from the menu bar.
2. When the VST Connections panel appears, click the Inputs tab.
3. The box under the Audio Device column may say “Not Connected”. If
it does, click in this box and select Lexicon IO 42 to enable the IO 42
inputs.
4. Close the VST Connections window.
You are now ready to start recording with Cubase LE, described in the next
section,