73
Primary/Secondary Master/Slave PIO
The four IDE PIO (Programmed Input/Output) fields let you set a PIO mode (0-4) for each
of the four IDE devices that the onboard IDE interface supports. Modes 0 through 4 provide
successively increased performance. In Auto mode, the system automatically determines
the best mode for each device.
The settings are: Auto (default), Mode 0, Mode 1, Mode 2, Mode 3 and Mode 4.
Primary/Secondary Master/Slave UDMA
Ultra DMA/33 implementation is possible only if your IDE hard drive supports it and the
operating environment includes a DMA driver (Windows 95 OSR2 or a third-party IDE bus
master driver)You’re your hard drive and your system software both support Ultra DMA/33
and Ultra DMA/66, select Auto to enable BIOS support.
Settings are: Auto(default) , Disabled.
OnChip Serial SATA
That it has 5 choices as below:
Disable
Disable SATA Controller.
Auto
By system determine automatically.
Combined Mode
PATA and SATA are combined. Max of 2 IDE drives
in each channel.
Enhanced Mode
( default ) Enable both SATA and PATA. Max of 6 IDE drives
are supported.
SATA Only
SATA is operating in legacy mode.
4-7-2
Super IO Function
Phoenix-AwardBIOS CMOS Setup Utility
Super IO Function
Item Help
Onboard Serial Port 1 [ 3F8/IRQ4 ]
Onboard Serial Port 2 [ 2F8/IRQ3 ]
PWRON After PWR-Fail [ Former-Sts ]
Menu Level
↑↓→←
:Move Enter:Select +/
- /PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6: Fail-Safe Defaults F7:Optimized Defaults