8
3.5-6
OCEAN
40~65
EVO®
40~65
3.5-7
3.5-8
3.5-9
GB
6. Take care to hold the gear stack in position as shown. Keep pawls and pawl springs in place while rebuilding/
placing the centre stem onto the base.
NOTE: If pawl gear falls away, ensure shoulder face is down on re-assembly. Take notes of gear and other com-
ponent positions if replacing the original stem with the conversion kit stem ready for reassembly.
7. Remove the base plate cover. Lift the base and bed down with a light
coating of sealing compound to prevent leaks.
• Avoid using excessive sealant.
8. Consult the fastening guide for bolt type and length. Bolt the base plate to the deck ensuring that all fasten-
ing heads are countersunk then replace base plate cover.
NOTE: If using silicone or other rubbery type sealant, it is advisable to allow curing of the sealant before final
tightening of the mounting nuts.
9. Refit the centre stem assembly, taking care to hold the gear stack in position as before. Rotating the gears
will facilitate re-engagement of the pawls and ratchet tracks.
• Replace the drum, collets and feeder arm in correct position and screw on the top cap.
DO NOT use a permanent
adhesive/sealant, eg. 5200.
Summary of Contents for EVO 40
Page 38: ...38 GB Notes...
