Lewmar EVO 40, Owners Installation, Operation & Servicing Manual

Page: 5 / 40

Lewmar OCEAN & EVO® Electric/Hydraulic Winches ref B2303 Iss.14 | 5
3.3-3
B
C
A
3.3-4 3.3-5
3.4-1 3.4-2
3. It is essential that the winch is fixed to an even surface for maximum performance.
4. If practical, for best performance, the winch should be installed so that the output gear (A) is situated in
the optimum position in relation to the load (B) and sheet line entry (C).
5.
Winches 40-65
Once position of winch is established, mark position of centre stem and drill Ø64mm hole. Strip winch (section
3.5) place base plate on deck then mark through mounting bolt holes, remove and drill to size of bolts.
Winches 68-111
Remove the winch drum. Access to mounting holes is available through holes in the base of the centre stem.
Mark hole positions and drill as necessary.
3.4 Below deck preparation
IMPORTANT: The positioning of the motor/gearbox or hydraulic drive unit must be checked prior to cutting for
deck/hull and bulkhead clearance.
1. The motor/gearbox can be rotated in 90 degree steps.
2. The motor rotation is factory set for fitting to drive shaft as shown.