![Lewmar AutoAnchor 150 Installation And Operation Instructions Manual Download Page 2](http://html.mh-extra.com/html/lewmar/autoanchor-150/autoanchor-150_installation-and-operation-instructions-manual_1886959002.webp)
PART 1 IMPORTANT INFORMATION
ReAd BeFORe INsTAllING OR usING The AA150
1
The AA150 is a rope and chain or chain only rode counter. It does not control
the windlass. A toggle switch, deck switch or handheld remote is required to
operate the windlass.
2
The AA150 can be fitted to most vertical windlasses. A horizontal windlass
may require a sensor holder or a custom designed sensor which is not
included in the standard pack. Check with your supplier or the AutoAnchor
manufacturer.
3
The AA150 should only be installed by a qualified marine electrician. Do not
attempt to install the AA150 unless you are suitably qualified.
4
The AA150 must be fitted to a windlass with a dual direction control box or
solenoid pack.
5
Information for installation and operation of the AA150 is supplied including
preset windlass profile lists and wiring diagrams. All instructions should be left
on board for the owner.
6
Non compliance with the instructions could impair the windlass and the AA150
operation, and could result in personal injury and/or damage to the boat.
7
Non compliance with the instructions will negate the manufacturer’s warranty.
8
The AA150 manufacturer and supplier accept no liability for personal injury
or property damage resulting from failure to follow the installation instructions
or the use of the AA150 in a way that may cause accidents or damage or
that may violate the law.
9
All the technical and cable specifications must be checked and adhered to.
10.
Wiring diagrams must be followed without modification.
11
Installation is not complete until the AA150 has been set up to comply with the
windlass and rode and then tested in a safe environment.
12
All installations must be carried out in accordance with USCG, ABYC, NMMA
and BMEA requirements.
13
This manual supports the installation and use of the AA150 only. The
appropriate manufacturer’s instructions must be followed for the installation
and use of the windlass it is connected to.
14
When this product reaches the end of its useful life it must be disposed of in
accordance with local regulations.
1
TABle OF CONTeNTs
PART 1
IMPORTANT INFORMATION
PART 2
INsTAllATION
PART 3
seT uP
PART 4
usING The AuTOANChOR 150
PART 5
MAINTeNANCe
PART 6
TROuBleshOOTING