background image

QUICKSTART GUIDE

STREAM 4x5

//

 Getting started

Download and install the LEWITT Control Center 2.0  
software (

https://lewitt.link/CONTROLCENTER

). 

Follow the on-screen installation instructions. 
Open the LEWITT Control Center 2.0 software. 
Connect your STREAM 4x5 to your computer  
via USB cable (bus-powered). 
Be careful! Always check output levels before using the  
STREAM 4x5 to avoid damage to your ears.

//

 I/O Section

USB connection (bus powered) – Connect  
your STREAM 4x5 to your computer
Input for external 5V power supply (optional)
Smart I/O – 3.5mm TRRS jack for bidirectional  
audio transmission 
1x 3.5mm stereo jack output – Connect your speakers
2x 6.3mm balanced audio jack – Connect your studio 
monitor speakers. 

PLEASE NOTE:

 Both speaker outputs are using the same 

signal. They always have identical output signal  
and level.
2x Mic/Line XLR/Instrument combo jack – Connect  
your microphone or instrument
1x 6.3mm headphone jack (front)

//

 User Interface

Input 1
Input 2
Clipping LED – Green = Signal ok, Orange = Low headroom,  
Red = Signal is clipping
Speaker output
Headphone output
Smartphone output
Top bar graph

 

Bottom bar graph
Jog dial

//

 Jog Dial Operation 

Push the jog dial to cycle through all available settings. 
Rotate the jog dial to change the selected value  
(e.g. set gain, output volume, etc.). 
Idle State – after 5 seconds of inactivity, the bar graphs switch 
to an idle state, showing input or output metering depending 
on the last setting you were making.

Figure 2 – I/O Section in the front of the interface 

Figure 3 – User interface 

Figure 4 – Jog dial 

Figure 1 – I/O Section in the back of the interface 

1

   

2
3

 

4

 
 

8
9
10 

11
12
13
14
15
16 

16

1

2

3

4

5

6

7

10

8

11 13

14

10

9

12

15

Summary of Contents for STREAM 4x5

Page 1: ...puts are using the same signal They always have identical output signal and level 2x Mic Line XLR Instrument combo jack Connect your microphone or instrument 1x 6 3mm headphone jack front User Interface Input 1 Input 2 Clipping LED Green Signal ok Orange Low headroom Red Signal is clipping Speaker output Headphone output Smartphone output Top bar graph Bottom bar graph Jog dial Jog Dial Operation ...

Page 2: ...is specific channel before the mixer s fader takes effect giving you the original signal independent from what is set in the mixer Send the SOLO signal to your speaker or headphone This does not affect the signal sent to the other outputs mixes Set solo output level Select hardware output Select Mix In general a mix combines multiple sound sources into one or more output channels In the process a ...

Page 3: ...channel Settings Interface Settings Sample rate fixed at 48 kHz Clock Internal Buffer size Low buffer sizes have low latency but are more CPU intense If you should experience audio drop outs select a higher buffer size Clip Hold Set the duration of the clipping LED if set to unlimited click on the meter to reset clipping LED Link MIX A MIX B A linked channel always has the same setting in MIX A an...

Page 4: ...n the integrated USB ports of your computer or on an active hub USB hubs without own power supply are not suitable for this device Always try an integrated USB port if the device does not operate properly Can you hear playback but not the input signal or vice versa Check your hardware input fader setting in the CONTROL CENTER 2 0 Minimum System Requirements PC Windows 7 8 or 10 PC or laptop manufa...

Reviews: