levr
LIM-05 user manual
Dated 25/5/2017
http://www.levr.pl/
Page
15
of
20
7
7
.
.
S
S
e
e
t
t
t
t
i
i
n
n
g
g
s
s
r
r
e
e
q
q
u
u
i
i
r
r
i
i
n
n
g
g
a
a
P
P
C
C
Implementation of certain settings in the LIM-05 locator requires using a computer
with suitable software, e.g. HyperTerminal. Both devices are connected with an RS232
transmission cable (three-wire crossover cable). The cable has to be terminated on both
sides with female connectors. The RS232 port is located on the front panel of the
locator. In order to ensure correct communication, the following transmission
parameters should be set in the computer:
57600,8,N,2
-
transmission rate = 57600 bps
-
number of bits = 8
-
no parity
-
number of stop bits = 2.
After you finish entering the settings, press the ENTER key on the computer. The
computer screen should display the following message:
LIM-05>
Absence of this message means that there is no communication between the computer
and the locator. In such a situation, make sure that the devices are correctly connected
and check the status of the selected COM port. You can enter the settings once the
“
LIM-05>
” message appears.
7.1 Setting the time
In order to set the time in the locator, enter the following command on the screen of
the terminal:
czas hh:mn:ss
where:
hh – hours
mn – minutes
ss – seconds.
Example: setting the time as 12 hours, 33 minutes and 30 seconds.
Type the following command on the computer screen:
czas 12:33:30
.
Press the ENTER key on the computer keyboard. The LCD of the locator should
display the requested time.
7.2 Setting the date
In order to set the date, enter the following command on the terminal screen:
data rrrr/mm/dd
where:
rrrr – year
mm – month
dd – day.
Example: setting the date as 2006/10/11.
Type the following command on the computer screen:
data 2006/10/11
.
Press the ENTER key on the computer keyboard. The LCD of the locator should
display the requested date.
