17
Resetting the Check
Filter Indicator
Reset the Check Filter Indicator when:
A.
lights up. This is the Check
Filter Indicator light.
1.
Replace the filter (see page 19).
2.
Turn on the air purifier.
CARE & MAINTENANCE
The Filter Button (
) will light up as
a reminder to check the filter. Depending
on how often you use the air purifier, the
indicator should turn on after about 12–15
months. You may not need to change your
filter yet, but you should check it when
lights up.
When your air purifier is set up with the
VeSync app, you can also check the app to
see your remaining filter life. You will also
receive a notification from VeSync when it’s
time to check your filter.
The VeSync app uses a scientific algorithm to
determine your filter life based on air quality,
amount of use, and other factors. The filter
life percentage is based on 12 hours of daily
use.
Check Filter Indicator
Cleaning the Smart Air Purifier
•
Unplug before cleaning.
•
Wipe the outside of the air purifier with
a soft, dry cloth. If necessary, wipe
the housing with a damp cloth, then
immediately dry.
•
Vacuum the inside of the air purifier.
•
Do not
clean with abrasive chemicals or
flammable cleaning agents.
The pre-filter should be cleaned every 2–4
weeks to increase efficiency and extend the
life of your filter. Clean the pre-filter using a
soft brush or vacuum hose to remove hair,
dust, and large particles. Optionally, you can
wash the pre-filter with water to remove dirt
and dust.
Note:
Avoid scrubbing, scraping, or
vigorously brushing the pre-filter.
Do not
use abrasive cleaning materials.
1.
Open the front cover and pull the pre-
filter out to remove it.
2.
Clean the surface of the pre-filter with a
vacuum.
[Figure 3.1]
Cleaning the Pre-Filter
Figure 3.1
3.
To reset the indicator light, press and
hold
button for 3 seconds.
4.
The indicator light will turn off when
successfully reset and the filter life
will show 100%.
B.
The filter was changed before
lit up.
1.
Press and hold the
button
for 3 seconds.
2.
The
will flash for 3 seconds.
3.
will stop flashing and turn off
when successfully reset. The filter life
will show 100%.
