10
Problem
Possible Solution
Strange smell coming from
the air purifier.
Clean the filter and aroma pad or replace if necessary.
Contact
Customer Support
Avoid using your air purifier in an area with high humidity.
The Check Filter Indicator
light is still on after replacing
the filters.
Reset the Check Filter Indicator (see page 7).
has not turned on after
4–6 months
is a reminder for you to check the filter and will light up based on
how much the air purifier has been used (see page 7). If you don’t
use your air purifier often,
will take longer to turn on.
turned on before 4
months
is a reminder for you to check the filter and will light up based on
how much the air purifier has been used (see page 7). If you run
your air purifier frequently,
will turn on sooner.
If your problem is not listed,
please contact
Customer Support
(
)
.
TROUBLESHOOTING (CONT.)
FEDERAL COMMUNICATION COMMISSION
INTERFERENCE STATEMENT – PART 15
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1.
This device may not cause harmful interference, and
2.
This device must accept any interference received, including interference that may cause undesired
operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate this equipment.
