11
I
DENTIFYING
C
ODES
FOUND
USING
THE
S
EARCH
P
ROCEDURE
1.
Press and hold the SETUP until the LED
indicator lights steadily. Release Setup button.
2.
Press the mode button that matches the
equipment you want to identify. The LED blinks
once.
3.
Press and release SETUP. The LED blinks once.
4.
To find the first digit, press each number button
from 0 to 9 until the LED blinks. The number you
pressed is the first digit of the code.
5.
Press each number button from 0 to 9 again as
above to find the second digit.
6.
Press each number button in turn to find the
third digit. When the third digit has been found,
the LED goes out.
6.
Press ENTER to confirm the setting.
C
HANGING
THE
H
OUSE
C
ODE
:
The Remote is factory programmed to House Code A. In most
cases you will not need to change this unless you are
experiencing interference from a neighboring Home Control
system. Receiver module codes must match the
Remote codes to operate.
1.
Press and release the button with the House
symbol on it.
2.
Press and hold SETUP until the LED indicator
lights steadily. Release Setup button.
3.
Use the number buttons to enter the number
equivalent to the chosen House Code (1=A,
2=B...16=P).
4.
Press the ENTER button to confirm the House
Code. The LED turns off.
14
DI-000-HCCUR-00B-prnspd
4/4/03, 11:35 AM
11
