Complete the Installation
51
properly.
1.
Power on both Express 250 charging stations at the breaker panel.
2.
If the stations do not power on and begin their configuration automatically after a couple of
minutes, go to
and find your region’s technical support number.
Identify the two stations you are installing or updating. Request confirmation that both charging
stations are running firmware version 7.0.4.x or higher. If not, ask the support technician to do
this now.
3.
On the front touchscreen, select a language for the Installation Wizard (this does not
permanently affect the Express 250’s display language).
4.
The next Installation Wizard test determines whether
all cover panels are correctly installed and fully seated.
Check the lower right corner of the screen for any
error messages. If panel errors appear, match the
panel letters to this illustration
.
a.
Front bottom panel
b.
Middle vent panel
c.
Front top panel
d.
LED display
e.
Area light bar
f.
Rear bottom panel
g.
Rear middle panel
h.
Rear top panel
i.
Left extrusion
j.
Right extrusion
If any panel needs re-installation, review the procedures above to double-check that all panels are
fully seated and that the edges of all signs are captured fully by the panels around them.
5.
Select the option “New installation”, whether you are installing two new stations or pairing with
an existing station. (The other option, “Replace Existing Station”, is only for stations where all
settings remain the same as before.)
Important:
Ensure both paired charging stations have the exact same version of firmware
before continuing. For example, two stations running 7.0.4.24 and 7.0.4.25 are not
sufficiently synced.
DANGER:
RISK OF SHOCK. If a fault exists, turn the power off during work and keep it off
until all panels are reinstalled. FAILURE TO FOLLOW THESE INSTRUCTIONS CAN RESULT
IN SERIOUS INJURY OR LOSS OF LIFE.
250_IGcombo.pdf 57
11/18/2019 3:37:42 PM
