Page 3
The Leviton 404CP and 408CP represents a key part of a state of the art, total lighting control
system. Combined with Leviton dimmers and optionally, a Leviton memory control console, a
totally integrated system is achieved.
The 404CP can automatically take control and preset the lighting level of up to 100 dimmer
channels, while the 408CP will control 45 of 100 dimmer channels. Control is automatically
passed between control panels and the memory control console as desired. The 404CP
features 4 scene control while the 408CP features 8 scene control. Both units have
programmable fade times and are exceptionally easy to operate. Remote lockout capability is
also included. Installation is a snap with the simple 4 wire digital connection required.
• Programming differs from other Luma-Net
®
panels, please read instructions.
• Luma-Net
®
control panels with software release 3.00 and higher are not directly compatible
and will not operate with older 400CP panels with software prior to release 3.00. Contact
dealer or factory for modifications if necessary.
• Leviton dimming systems used with these release 3.00 panels require the following
software releases:
2408CD, 2408CR, 2404CD release 2.30 and above.
DDS 8600/8800/9600/9800 release 1.30 and above. *
DDS 6000 release 1.30 and above. *
DDS 5300/5500/5600 release 1.30 and above. *
* Optional interface kit required for these units.
WIRING
The 404CP and 408CP will only operate with Leviton dimming and control systems explicitly
designed for interfacing with it. Communication between the panels and the dimming system
is via a 4 wire interface. Three wires carry the RS 422/485 bi-directional data. A fourth wire
carries the DC voltage necessary for powering the unit.
Wiring cable between the panels and the dimming system is class 2 and should be at least
22 AWG, 4 conductor shielded, twisted pairs (BELDEN 8302, 8723; 22 AWG).
The 404CP and 408CP may be connected to the dimming system via parallel or daisy-chained
wiring. Due to power supply current demands, panels must be limited to 5 units per daisy
chain run with 22 AWG wire, or 10 units with 20 AWG wire.
The Luma-Net
®
panels feature plug on wiring terminals. The terminals may be unplugged
from the panel to facilitate ease of wiring and testing. Connect the terminals marked ,
remote-, common, and +15 VDC to the same respective terminals on the dimming system and
other Luma-Net
®
panels. Use one twisted pair for and remote- and the other pair for
common and +15 VDC.
The wiring to the remote lockout switch, if used, can be simple 2 conductor 22 AWG. Connect
the wires from the switch to the and lockout- terminals. Any panel or group of panels
may be locked-out remotely by interrupting the +15V supply to the panels. This should not
affect any other panels still powered, or affect lighting levels currently set.
IMPORTANT:
Verify wiring is correct before powering system! Make sure nothing conductive
may touch pc board or components!
Introduction
Important
Wiring
WEB
VERSION
