IMPORTANT SAFETY INFORMATION
Read these safety warnings before operation.
WARNING!
Failure to heed
these warnings may results in loss of load, damage to jack stands, and/or jack
stand failure resulting in personal injury or property damage.
WARNING!
Do not overload jack stands beyond rated capacity. Overloading can cause damage to or failure of the
jack stands.
POSITION LOAD ON CENTER OF SADDLE ONLY. ALWAYS USE STANDS IN PAIRS ON
HARD, LEVEL SURFACE CAPABLE OF SUSTAINING THE LOAD. USE OF STANDS ON
OTHER THAN HARD LEVEL SURFACES CAN RESULT IN STAND INSTABILITY AND
POSSIBLE LOSS OF LOAD.
OPERATION
1.
Refer to your vehicle owner´s manual for proper jacking procedures. Lift only on areas of the
vehicle as specified by vehicle manufacturer.
2.
Position stands under vehicle at points specified by vehicle manufacturer as proper load support
points.
3.
To adjust stands: Hold control lever up while lifting saddle shaft to desired height. Push control lever
down to lock pawl into teeth located in center column.
MAKE SURE PAWL IS FULLY ENGAGED INTO TEETH.
4.
Carefully lower load onto stands
MAINTENANCE AND INSPECTION
1.
Visual inspection shall be made before each use of the stands, checking for cracks, cracked welds
and missing and/or damaged parts. Any stand that appears to be damaged in any way shall be
removed from service immediately.
2.
BECAUSE OF THE POTENTIAL HAZARDS ASSOCIATED WITH THE MISUSE OF
EQUIPMENT OF THIS TYPE, NO MODIFICATIONS SHALL BE MADE TO THE PRODUCT.
