Chapter 8 Wireless configuration
http://www.level1.com
Page 72
the fixed IP access to the default Internet line in
Network parameters —> WAN port
configuration
page, or directly enter the
Start--> Configuration wizard > Network parameter
s
page to configure the line. After the default Internet access line is configured correctly, the
system-reserved NAT rules corresponding to the default line will be automatically generated, and
the NAT function is automatically enabled.
And this enterprise provides four internal servers for external access, so it is also necessary to set
an NAT rule with the type of "One2One".
Configuration steps are follows:
The first step is to enter the
Advanced configuration -> NAT and DMZ configurations ->NAT
rules
page, and click <Add new entry>.
The second step is to enter the NAT rules configuration page, and fill in "Server" in the "Rule
name".
The third step is to select "NAT type" as "One2One".
The fourth step is to fill in202.1.1.131in the "External starting IP address". Fill
in192.168.1.200and 192.168.1.203 in "Internal starting IP address" and "Internal ending IP
address" respectively.
The fifth step is to select the rule-bound interface as WAN1 port.
The sixth step is to click <Save>, and the NAT rule is configured successfully.
Figure 8_9
NAT rule Settings
—One2One
8.2
Static Route Settings
This section describes the
Advanced Configuration-> Routing configuration
page and
configuration methods.
