Setup
21
Mode Screen
This page allows you to switch the WBR-6010 between Wireless Router and Access
Point configurations.
Figure 7: Wireless Screen
Modes
Router
In this mode, this device can provide shared Internet Access to
all your LAN users. Also, by default, it acts a DHCP Server,
providing an IP address and related information to all Wireless
and LAN users.
It is the default mode of the WBR-6010.
Access Point
In this mode, the unit does not perform any changes to the
network traffic passing through it. It is used purely to relay the
wireless traffic. You‟ll need to have a DHCP Server on your LAN
to provide IP addresses to the Wireless and LAN clients using
this Access Point.
This mode can be used as a second wireless access point to
extend and relay the wireless signal over a greater area.
IP Address:
Set the IP Address of the WBR-6010, when
used as an Access Point. Be careful not to
conflict with existing IP Addresses.
Subnet Mask:
Enter the Subnet Mask that matches that used
in your other LAN devices.