48
trigger active until the alarm is released. Set the Image frequency as the upload frame
rate. The setting range is from 1 frame to 15 frames.
NOTE:
Make sure FTP configuration has been completed. Refer to FTP
for further details.
Upload Image by E-Mail
Select this item and the Administrator can assign an e-mail address and configure
various parameters. When the alarm input is triggered, event images will be sent to the
appointed e-mail address.
<Pre-trigger buffer> function allows users to check what happened to cause the trigger.
The <Pre-trigger buffer> frame rate could be pre-determined.
On the other hand, <Post-trigger buffer> is for users to upload certain amount of images
after alarm input is triggered. Check the box <Continue image upload> to upload the
triggered images during certain time or keep uploading until the trigger is off. Select
<Upload for __sec> and enter the duration in the blank. The images of the duration will
be uploading by E-mail when the alarm input is triggered. The setting range is from 1 to
9999 seconds. Select <Upload during the trigger active> to make the images keep
being uploaded to E-mail during the trigger active until the alarm is released. Set the
Image frequency as the upload frame rate. The setting range is from 1 frame to 15
frames.
NOTE:
Make sure SMTP configuration has been completed. Refer to Mail
for further details.
Send HTTP notification
Check this item, select the destination HTTP address, and specify the parameters for
event notifications by <Alarm> triggered. When an alarm is triggered, the notification
can be sent to the specified HTTP server.
For instance, if the custom parameter is set as” action=1&group=2”, and the HTTP
server name is” http://192.168.0.1/admin.php”, the notification will be sent to HTTP
server as” http://192.168.0.1/admin.php?action=1&group=2” when alarm is triggered.
Record Stream to SD Card
Select the item and the alarm-triggered recording will be saved into your Micro SD card.
