3rd Stage:
Optional 12”
HEPA filer
Optional 12” Hepa Filter
Figure 2.
(*) Lev-co has a policy of continuous research and improvement, and reserves the right to change design and specifications without notice.
INSPECTION AND UNPACKING
Inspect your LEV-CO unit for shipping damage immediately upon receipt, save all packaging materials until
unit has been received, inspected and accepted.. Damaged carton(s), broken crate(s), etc. are indications that the unit
may have been damaged in shipment. It is also possible shipping damage may be concealed and not noticed until the
unit is installed and in operation. If any damage is found, notify your delivery carrier at once and enter a claim. Claims
must be filed within 24 hrs of receipt of shipment.
FREIGHT DAMAGE CLAIMS ARE THE RESPONSIBILITY
OF THE PURCHASER, NOT LEV-CO.
After initial inspection for shipping damage, check the cabinet filter and
motor/blower compartments for any packing materials and remove.
PREPARATION AND INSTALLATION
After initial inspection for shipping damage, open the cabinet and motor access door. Remove all packing
materials and filters to avoid damage and to facilitate the installation. The installation should conform to all local
ordinances associated with building and electrical codes required for the unit. Authorities having jurisdiction should
be consulted before installation is made. If there are no local codes, the installation should conform to the National
Electrical Code. The MULTI-FLEX can be used as either a roll-around portable unit, wall mounted or suspended.
If
using an extension cord with the portable unit refer to the Appendix, Motor Troubleshooting Guide, Table
A for the correct wire gauge.
The following section discusses both physical installation and electrical tie-in.
Fire
suppression equipment provided by others.
If an optional light kit was ordered, this manual will be accompanied
by a Light Kit Manual with an instruction sheet for light kit service and operation.
Page:
6/15 .
