Leuze BPS 300i, Original Operating Instructions

Page: 34 / 94

Mounting
Leuze electronic GmbH + Co. KG BPS 307i 34
6.1.2 Cutting bar code tapes
NOTICE
Avoid cutting BCB!
Ä
If possible, avoid cutting bar code tapes.
Optimum position value determination by the BPS is achieved with continuously affixed
BCB.
Ä If there are mechanical gaps, first affix the BCB continuously. Then cut the BCB.
The BCB is cut at the indicated cut marks:
1
000040 000044 000048 000052 000056
G40 Leuze G40 Leuze G40 Leuze G40 Leuze G40 Leuze
1 Cut mark
Fig. 6.1: Cut mark on the bar code tape
If another BCB is to be affixed directly after the preceding BCB, the subsequent bar code value must differ
from the preceding BCB by at least 1 m:
1
000040 000044 000148 000152 000156
2
3
G40 Leuze G40 Leuze G40 Leuze G40 Leuze G40 Leuze
1 Preceding bar code tape
2 Cut mark
3 Subsequent bar code tape, value range + 1 m
Fig. 6.2: Cut bar code tape
If there is a gap without tape after the preceding BCB, it must be at least 300 mm wide before the subse-
quent BCB is affixed. The first bar code value of the subsequent BCB must differ by at least 20 (200 mm)
from the last bar code value of the preceding BCB.