Technical data
Optical data
Scanning range
13mm ± 3mm
Light source
1)
1) Average life expectancy 100,000h at an ambient temperature of 25°C
LEDs (red, green, blue)
Light spot dimensions
1mm x 4mm (at a distance of 13 mm)
Light spot orientation
vertical (lengthwise) or horizontal (transverse)
Timing
Switching frequency
15kHz
Response time
33μs
Conveyor speed
(during dyn. 2-point teach)
≤
0.1m/s (with 1mm mark width)
Readiness delay
< 300ms
Electrical data
Operating voltage U
B
2)
2) For UL applications: use is permitted exclusively in Class 2 circuits according to NEC
12 … 30VDC (incl. residual ripple)
Residual ripple
≤
15% of U
B
Open-circuit current
25mA (at 24V)
Switching outputs/functions
OUT1
push-pull switching output (high signal on mark)
OUT2
push-pull switching output (low signal on mark)
Signal voltage high/low
≥
(U
B
-2V)/
≤
2V
Output current
max. 100mA
Indicators
Green LED continuous light
ready
Yellow LED continuous light
mark detected
Green and yellow LED flashing (2Hz)
teach-in active
Green and yellow LED flashing (8Hz)
teaching error
Yellow LEDs - special functions
light/dark switching
Mechanical data
Housing
diecast zinc, chemically nickel-plated
Connector
diecast zinc, chemically nickel-plated
Optics
PMMA
Operation
2 teach buttons for mark (M) and background (B)
Weight
60g
Connection type
M12 connector, 5-pin
Environmental data
Ambient temp. (operation/storage)
-40°C … +60°C/-40°C … +70°C
Protective circuit
3)
3) 2=polarity reversal protection, 3=short circuit protection for all transistor outputs
2, 3
VDE safety class
4)
4) Rating voltage 50V
III
Degree of protection
IP67, IP 69K
Light source
exempt group (in acc. with EN 62471)
Standards applied
IEC 60947-5-2
Certifications
UL 508, C22.2 No.14-13
2)
5)
5) These proximity switches shall be used with UL Listed Cable assemblies rated 30V, 0.24A min,
in the field installation, or equivalent (categories: CYJV/CYJV7 or PVVA/PVVA7)
Chemical resistance
tested in accordance with ECOLAB
Additional functions
2 teach processes
static teach on background and mark
dynamic teach on background and mark
Light/dark switching (L/D)
can be activated via control button
KRT18BM
Notes
Glossy objects:
With glossy objects, the
sensor is to be fastened at
an inclination of
approx. 10° … 15° rela-
tive to the object surface.
Alignment aid:
An alignment aid is
included in the scope of
delivery of each sensor.
This facilitates simple
alignment of the sensor to
the working distance of 13
mm without needing to
perform electrical
commissioning.
Observe intended use!
This product is not a safety sensor
and is not intended as personnel
protection.
The product may only be put into
operation by competent persons.
Only use the product in accor-
dance with its intended use.
10°…15°
13
mm
13
mm
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: [email protected]
