Online commands
Leuze electronic
BCL 95
46
Deactivate sensor input
Command
’-’
Description
The command activates decoding.
Parameter
None
Acknowledgment
None
Activate switching output
Command
’OA’
Description
The command activates the switching output.
Parameter
’OAx’: Activate switching output
x
Switching output no.
’1’
(Output 1)
Acknowledgment
None
Deactivate switching output
Command
’OD’
Description
The command deactivates the switching output.
Parameter
’ODx’: Deactivate switching output
x
Switching output no.
’1’
(Output 1)
Acknowledgment
None
8.4
Online commands for the parameter set operations
Definitions
•
<BCC type>
Type of checksum calculation.
’0’
: No checksum
’3’
: XOR checksum (mode 3)
•
<PS type>
Parameter set type
’0’
: Current parameter set (data stored in the EEPROM (non-volatile))
’1’
: Reserved
’2’
: Standard parameter set (not changeable)
’3’
: Operating values (data in the RAM, will be lost after reset)
•
<Status>
Mode of parameter processing
'0'
: Does not perform a reset following the write operation; no other parameters follow.
'1'
: Does not perform a reset following the write operation; other parameters follow.
'2'
: Subsequently performs a reset, no additional parameters follow.
•
<Start address>
Relative address of the parameter within the parameter set
•
<Para0L> <Para0H>… <Para122L> <Para122H>
:
Parameter set data of the message. The sequence of the data is arranged identically to the device, i.e.
when a word is transmitted, first the low byte is sent then the high byte. The parameter set data is con-
verted for transmission from HEX format to a 2-byte-ASCII format. During the conversion, two ASCII
characters – representing the
lower nibble
and the
higher nibble
– are created for each HEX value.
