Leupold RCX Trail Camera System, User Manual, Page: 4 / 17

6 7
A controller must only be set once, but
is necessary to set the date and time,
and to access the features of your RCX
Camera. Every time a new camera is
set up, the time synchronizes with the
controller as soon as it is plugged in
with the USB cable.
The first time the controller is powered
up, the first screen presented is the
“Time/Date” screen. To access this
screen again later, you will find this
selection in the “Setup Controller”
menu. This screen will again be the first
screen presented any time you allow
the battery to go dead for more than
24 hours.
The Lithium Ion battery is already
installed in the controller. The
controller battery should be charged
for a minimum of 2 hours before use;
however, it is preferable to charge it at
least 16 hours to ensure long hours of
use and to prevent short battery life.
To charge the RCX Controller Battery,
plug the appropriate end of the USB
cable into the controller, then plug the
other end into a computer, the wall
charger or the car charger provided.
Before going into the field, verify that
the controller is properly charged.
Navigate through the controller
menus by arrowing to the desired
selection.
On menu items with to the right
of the text, press the right arrow to
access the next level down in the
menu .
Press to select a menu choice.
Delete and zoom are used
only when viewing images on the
SD card.
Use to back out one menu level.