Step 2: Mounting the WingMan Base Plates
Attach the front WingMan base to the Teleporter using the
5/16” hardware and Hat Brackets. Position the WingMan
base so it is touching the slide bumper at the front of the
Telescope Tube. Attach the telescope cable loop between
the forward Hat Bracket (vehicle side) and the WingMan
base as shown. Tighten hardware until snug or to 18 foot
pounds.
Install the rear WingMan base plate using 5/16” hardware
and Hat brackets near the end of the Telescope Tube.
V4 Teleporter Bike Rack
VME-V4 - v1
Step 3: Assemble Wings
Slide Wings into the WingMan Base pockets and
secure the Wings to the Base with the Wire Lock
Pins.
Step 4: Attach Wheel Cradle Assembly
Determine the approximate center-to-center dis-
tance between the hubs of the bike wheels and
attach the wheel cradles to the Wings with the Hair
Pin Clips to match this distance.
Assembly
Position the Tilt Tube in the horizontal position and lock
into place with the black handled Tilt Pin. Lightly rub the
top and side surfaces of the Tilt Tube with the included
bar of parafin wax to ensure smooth telescoping action
and protect the surface of the tube.
Insert the Teleporter Shank in the hitch as shown
with
the structural rise above the hitch
. Attach using the
Silent Hitch Pin®, threading the Silent Hitch Pin® into
the pre-installed Spring Nut in the Shank Tube. Tighten
firmly with a 7/8” wrench. Apply pin clip.
Slide the Telescope Tube onto the Tilt Tube and attach
using the Silent Hitch Pin® with Handle. Attach the
Safety Cable to the side plate with the caribiner.
Step 1: Installing the Teleporter Base
Tilt Pin
Safey Cable
attachement
hole
Silent Hitch
Pin®
Silent Hitch Pin® for hitch
location
Silent Hitch Pin® for Telescope
Tube location
Tip: For added bumper clearance, move Spring Nut to
the other available shank hole and thread pin.
IMPORTANT: For proper function in the hitch, Silent
Hitch Pin® must be tightened with a wrench to 30 ft.
lbs. - 60 ft. lbs.
