Let's Go Aero Half Nelson, Product Manual

Page: 7 / 10

Page 7 of 10
Using the 72in Cable (with Large Loop) [CC] , slide the small (SM) loop
through one Ring Pin [AA] that secures the Wing to the Stem [Q] .
Slide the small loop through the large (LG) loop on the 72in Cable [CC]
to create a closed loop.
Continue using the small loop end of the 72in Cable [CC] to secure the
carrier by sliding the small loop end through the second Ring Pin [AA]
and then finish by securing the small loop over the Spin Pin [S] post
that is threaded through the Stem [Q] . [Fg. 23]
NOTE: The 72in Cable [CC] is designed to lock bicycles to the carrier.
When no bicycles are mounted (like the example currently shown in
Fg. 21) it is recommended to wrap excess slack on the cable around
the Stem [Q] before sliding the small loop end over the Spin Pin [S] .
Install the included Lock [DD] over the Spin Pin [S] locking both
Cables [CC & DD] onto the Spin Pin [S] . [Fg. 24]
STEP 14: Lock Rack to the Vehicle with 60” Cable
STEP 15: Lock Wings to the Rack with 72” Cable
STEP 16: Apply Lock
Using the 60in Cable (with Ball Stop)
[BB] pre-installed into the Rear Cab
Bar [B] , thread the 60in Cable [BB]
through each Adjustment Bolt [J]
and through each Ring Nut [E] along
the carrier. [Fg. 21 & 22]
Slide the small loop over the Spin
Pin [S] post that is threaded through
the Stem [Q] .
BB
BB
CC
LG LOOP
SM LOOP
DD
AA
E
S
S
S
B
J
[Fg. 21]
[Fg. 23]
[Fg. 24]
[Fg. 22]