PAGE 7 OF 21
Adjust the distance between the Frame Angles [
L
] so
the Frame Bars [
EE
] are approximately 18in apart.
Lay the four (4) U-Tubes [
U
] on top of the Frame Bars
[
EE
] [Figure 15].
The holes in the Frame Bars [
EE
] should line-up and
match with the holes in the bottom of the U-Tube [
U
].
STEP 11
U
EE
L
[Figure 15]
STEP 12
W
EE
O
P
U
S
L
[Figure 16]
TOOLS: 1/2” WRENCH & 3/16 HEX KEY
Lay two (2) Floor Panels
[
S
] over the U-Tubes [
U
].
NOTE:
The third/center
Floor Panel [
S
] is not
attached in the same
manor as the two (2) Floor
Panels in this step and
should not applied at this
time.
NOTE:
The holes in the
Floor Panels [
S
], U-Tubes
[
U
], Frame Bars [
EE
] and
Frame Angles [
L
] must
align.
Connect the Floor Panels
[
S
], U-Tubes [
U
] and
Frame Bars [
EE
] using
eight (8) 8mm x 70mm
Button Head Bolt [
W
], eight
(8) M8 Carriage Washers
[
O
], and eight (8) M8 Lock
Nuts [
P
] [Figure 16].
Fully secured these
connections.
