Page 3 of 4
Slide both Wings
[Z]
into the tubes located on the Base
[N]
aligning
the holes at the bottom of the Wing with holes on the Base.
Thread one (1) Wire Lock Pin
[BB]
into the holes located on each
Base
[N]
port
securing the Wings to the Base
[N]
. [Fg. 8 & 9]
NOTE:
The Wire Lock Pin
[BB]
MUST
always be threaded through
the hole in the Base
[N]
from above/inside the
Base as shown.
Pull out the Knobs located on the two (2) Cradle Housing
[AA]
installed
above
the foam bumpers on each Wing
[Z]
and insert two (2) Upper Wheel Cradles
[W]
with Rubber Straps
[Y]
facing in opposite directions as shown.
[Fg. 6 & 7]
STEP 4:
STEP 5:
STEP 6:
[Fg. 8]
[Fg. 9]
BB
N
Z
X
W
Slide the round end of one (1) Rubber Strap
[Y]
onto
each Upper Wheel Cradle
[W]
and Lower Cradle
[X]
. [Fg. 5]
NOTE:
Be sure to slide the Rubber Straps
[Y]
all the
way onto the cradles so that it tightly rests
over
the
plastic coating of the Wheel Cradle
[W & X]
.
[Fg. 5]
Y
Y
AA
AA
W
Y
Y
[Fg. 6]
Install two (2) Lower Wheel Cradles
[X]
with Rubber Straps
[Y]
facing in
opposite directions as shown. [Fg. 6 & 7]
[Fg. 7]
X
Y
