Wi2U mounting
The Wi2U router can either be affixed in the glove compartment by using the Vel-
cro strips provided, or screwed through the housing bore in the plastic casing using
the screws. When mounting the Wi2U with the screws provided, the existing device
screws must be removed beforehand. When using the Velcro strips ensure the surface
is free from grease and apply the Velcro strips with high pressure.
Before mounting, please disconnect all connection cables according to the drawing on
the Wi2U router above.
The Wi2U router is preconfigured to operate only when the ignition is switched on. The
start-up time is approximately 30 seconds.
B) Installation in the boot
The Wi2U router can alternatively be installed in the boot of the vehicle.
1. Affix the UMTS antenna and optional GPS antenna to the inside of each side win-
dow (if possible, one antenna on the left side of the vehicle, the other on the right side
of the vehicle to prevent mutual interference).
28
Glove compartment
Glove compartment
2. Further installation procedures for connections and mounting are identical to glove
compartment installation.
Start-up
1. Insert the SIM card into the
SIM card slot (pictured on the right).
2. Switch on the ignition.
Wi2U will start (Power LED and WLAN LED light up).
3. Establish a WLAN connection to the Wi2U.
The Wi2U is preconfigured with the following settings:
SSID
(Network name)
WPA (TKIP) / WPA2 (AES)
(WLAN key)
The device-specific settings can be found on page 23 of this manual and also labelled
on the underside of the device. Use the normal WLAN application on your computer to
connect. Search for a network and click on „
Connect“
with the SSID of the Wi2U router.
Enter the WPA2 key.
4. Launch the Internet Browser on your computer and enter the following address
„
http://router.wi2u“.
The start window of the Wi2U web server will open and you will be prompted to enter
the
PIN
for your SIM card.
29
GPS (optional)
UMTS
public hotspot
English V
ersion
Wi2U public hotspot
| Quick Start Guide
