26
A) Installation in the glove compartment
Antenna and cabling installation
It is recommended to install the antennas as shown in the following diagram below
(please ensure to use the adhesive pads provided). All connection cables mentioned
are to be laid in the glove compartment.
The Wi2U is delivered with a cable set for connection to the on-board electronics (12V
or 24V) and a connection for the cigarette lighter. Select the right cable and connect
it to the corresponding connections in the vehicle. Please ensure that ignition on/off
recognition does not function when connected via the cigarette lighter.
Option 1: (Connection to the cigarette lighter)
Connect the UMTS antenna, and, if required, the optional GPS antenna according to
the colour coding of the Fakra connector to the appropriate connector socket on the
Wi2U. Take the cable for the cigarette lighter and insert the 4-pin connector into the
corresponding socket of the Wi2U. Plug the other end of the cable into the cigarette
lighter socket of your vehicle.
Option 2: (Connection directly to vehicle on-board electrical system)
Connect the UMTS antenna and the optional GPS antenna according to the colour
coding of the Fakra connector to the appropriate connector socket on the Wi2U. Take
the cable for the on-board electronics and insert the 4-pin connector into the corre-
sponding socket of the Wi2U. Connect the other cable to the on-board electronics of
your vehicle. When doing so, please observe the following connections:
Yellow cable to terminal 15 (ignition on/off)
Red cable to terminal 30 (vehicle battery 12V or 24V)
Black cable to ground
For details about the connection to vehicle on-board electrical system please refer to
Chapter „
Technical Data“ and „Important Notes“
.
27
Cigarette lighter
UMTS
GPS (optional)
English V
ersion
Wi2U public hotspot
| Quick Start Guide
GPS (optional)
UMTS
WLAN
Strom-
versorgung
Do not obstruct the field of vision
Power
supply
public hotspot
Vehicle on-board electrical system
KL15 KL30 Ground
