9
Leslie 3300 Owner’s Manual
HOOK-UP WITHOUT ANY LESLIE CONNECTOR
SINGLE CHANNEL HOOK-UP WITH AN 8-PIN LESLIE JACK
Applicable HAMMOND Models: XB-1, XK-1, XM-1, XM-2
1. Connect the optional Leslie 8-pin Cable (LC8-7M) as shown above.
2. Set the VOLUME control on the Leslie 3300 to the 3 position.
3. Turn the Power switch on the organ to the ON position.
4. Turn the Power switch on the Leslie 3300 to the ON position.
NOTE: The Remote mode does not function when the 8-Pin Cable is
used.
5. Switch the Leslie speed switch on the organ from Slow to Fast. The rotors
in the Leslie 3300 should simultaneously change speeds from Slow to Fast
and the Rotor Mode Indicator lights should switch from Slow to Fast.
6. While playing the organ at maximum volume, adjust the VOLUME setting
on the Leslie for the desired volume level.
1. Connect the LINE OUT from the Organ to the LINE INPUT Jack on the
Leslie 3300 by means of a ¼” phone cable (available at your local audio
store).
2. Plug the FS-9H Foot Switch into the FOOT SW jack on the Leslie 3300.
3. Set the VOLUME control of the Leslie 3300 to the 3 position.
4. Switch ON the power of the Organ.
5. Switch ON the Power of the Leslie 3300.
6. The Rotor Mode Indicator lights of the Leslie 3300 should light and the
rotors should start to turn.
7. Momentarily depress the Foot Switch and the Leslie should change speeds,
either Slow to Fast or Fast to Slow speed. If you depress the Foot Switch for
1.5 seconds or more, the rotors in the Leslie will stop rotating.
8. While playing the organ at maximum volume, adjust the VOLUME setting
on the Leslie for the desired volume level.
NOTE: If you have a built-in Leslie Simulator in your organ, turn in OFF
when using the Leslie 3300. Refer to your organ’s owners manual
for reference if required.
Steps:
Steps:
USING MULTIPLE LESLIE CONNECTORS SIMULTANEOUSLY
You can use the 11-pin, 8-pin and the LINE Inputs on your Leslie
3300 at the same time under the following conditions.
The sounds from all the Inputs will be mixed.
You can switch the speeds of the Leslie by either the organ connected
to the 11-pin Leslie connector or the 8-pin Input. On the organ that you
do not want to have the ability to change Leselie speeds, set the Leslie
Switch to the Leslie OFF(OFF MODE = BREAK) or STOP position.
You can also control the speeds of the rotor by the Foot Switch simul-
taneously with the Leslie switches on the organ that is setup to control
the Leslie. The Foot Switch will have priority control over the Leslie
switch on the organ.