Page 4 of 5
Step 1 -
The wall mount uses fasteners and back plate provided
with AR13/18. Insert the back plate inside the wall mount
with slotted hole facing up. Insert bolt provided through the slotted
hole and into threaded hole at the top center of the wall mount.
Tighten bolt so back plate is secure against the back side of the wall
mount with top of slotted hole resting on top of the bolt.
Arieta LED Area Light - AR13/AR18 Series
Wall Mount Option (WM) Installation Guide
A
B
C
D
Step 3 -
Open the Arieta power door and insert the
bolt protruding from the wall mount through the center
top slotted hole in the mounting base of the Arieta
luminaire. Rest the fixture on the bolt and secure it with
washer and nut provided.
Step 4 -
Insert and tighten the second bolt provided into
the corresponding threaded hole in the back plate.
C
B
Step 2 -
Drill four mounting holes in wall corresponding with
template shown. Secure the wall mount to the wall with 1/4”
anchor bolts (provided by others). Use bolts and anchors that
are appropriate for mounting surface. Use flat head bolts if
flush look is desired. Wiring may be run directly through the
large center hole or through knockouts for 1/2” conduit on top,
bottom and sides of wall mount to accommodate surface wiring.
B
A
D
A
Step 1
Step 2
Steps 3 & 4
Knockouts for 1/2” conduit
D
2.75”
9”
© 2019 Leotek Electronics USA LLC
AR13-18_Installation_Guide_N-Series_02-13-19
